Mosfet GATE TITAN V2 ADVANCED SET rear wired

ADAPTATION OF THE TRIGGER SENSITIVITY

Five trigger sensors allow easy sensitivity adjustment. You don't have to disassemble your AEG every time, just use the Tactical Programming Card or GATE Control Station to adapt the settings to your preferences and experience.

CONFIGURABLE FIRE SELECTOR (gen. 2)

Two selector sensors allow setting up to six selector operating modes, together with the innovative SEMI-BURST-AUTO mode:

    SAFE-SEMI-AUTO
    SAFE-SEMI-SEMI
    SAFE-SEMI-BURST
    SAFE-AUTO-BURST
    SAFE-SEMI-BURST / AUTO (short shot - BURST, long shot - AUTO)
    SEMI-BURST-AUTO (SAFE mode after fast change SAFE-SEMI-SAFE)

REVELATION OF CYCLES

Thanks to the rack sensor, the TITAN reveals precisely when the cycle should be terminated. Thus, even when the trigger is pressed for a short time, a complete cycle is obtained at minimum.

Thanks to the cycle detection function you have:

    Automatic BURST - you don't need to set the burst duration manually. You can set the burst between two and 10 shots;
    Automatic PRE-COCKING - The pre-cocking is fully functional both in SEMI, BURST and AUTO mode. You can easily set the pre-cocking boost as high (high), medium (mid) or low;
    COMPLETE CYCLE - when the pre-cocking is deactivated, the TITAN does not allow to pull the piston after the shot. The piston stops in the front position eliminating unnecessary stress and increasing the vitality of the gearbox and its components. It is very important especially in the case of strength tuning of the replica.


        PRE-COCKING (gen.2 *)

    Victory in the game is often a matter of fractions of a second. Thanks to Pre-cocking (Pre-cocking), you get a trigger reaction like a real gun. It allows the compression of the initial spring, which accelerates the response of the trigger significantly. There are two Pre-cocking modes:
    AUTO MODE - the spring is automatically compressed after each stroke,
    TRIGGER MODE - the slight trigger action compresses the spring, and the strong trigger action fires the shot.

And three options PRE-COCKING BOOST: HIGH / MID / LOW.

* In the new generation, pre-cocking is fully functional both in SEMI, BURST and AUTO modes. It is not necessary to set the pre-cocking boost in manual.

Please note: in Pre-cocking wear increments on the Gear Box.

BURST (gen.2 *)

This function allows you to limit the series of shots which is useful in MILSLIM and when you use the low-cap loader.

* It is not necessary to set the burst duration. You can set the burst between the two and 10 shots.

FIRE CONTROL RATE

It allows the reduction without loss of fire rate of the rifle that allows you to reduce the speed of shooting your replica in such a way as to use LiPo accumulators and despite this have ROF as in real weapons.

STABILIZATION OF SHOOTING SPEED

It allows you to modify the operating principle of adjustment of the shooting speed:
ON - Adjusting the shooting speed uses the PWM so it happens in a smooth way. This reduces the consumption of the internal parts of the rifle.
OFF - Adjustment of shooting speed adds intervals between shots to reduce ROF. This way you get a more real experience.

SNIPER DELAY

It allows you to add the delay between SEMI shots to simulate recharging or recoil. You can set the delay of 0.5s, 1s, 2s or 3s.

INTELLIGENT SPIDER

We know how vital the fast trigger response is during combat. It enables you to get a quicker activation response. Works with the ROF control system. During the first shot, the microprocessor sets the ROF control to 100%. After the first shot, you pass to a previously programmed value (for example 50%). As a result, the first shot is fired at a full rate of fire, and subsequent blows to the reduced ROF. The best results are obtained by using a battery with a voltage higher than the standard one. For example, if you are using a 7.4 V battery, you can replace it with 11.1V. In this way, you will get a faster trigger response with the same rate of fire as with a standard battery. In this way, we will get a more reactive trigger with the same rate of fire as with a standard battery.

* Works only with stabilization of activated firing speed.


AUG MODE

Enjoy a two-stage trigger. Activate AUG and choose two different trigger sensitivities. A light push of the trigger involves the SEMI or the BURST series. The additional thrust of the trigger involves the firing of a BURST or AUTO series (depending on the fire selector mode).

BATTERY PROTECTION (gen.2 *)